User's Manual

Telink EVK TLSR8208ADK56D user manual
Telink Confidential and Proprietary 7 Ver.0.1.0
1.5 Functions of each module
As shown in figure 2-4, The functions of each module on the board have been marked.
There are LED, key, ANT, E
2
PROM port and debug port on board. The LED lights can indicate what status
the TLSR820ADK56D is in. The key allow us to control TLSR8208ADK56D. We can use debug port to debug
TLSR8208ADK56D.
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.This equipment complies with FCC exposure limits set
forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of
20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate
the equipment