User's Manual

CE910-DUAL Hardware User Guide
1vv0301010 Rev .0 – 2012-07-10
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 45 of 63
10. General Purpose I/O
The general-purpose I/O pads can be configured to act in three different ways:
 Input
 Output
 Alternate function (internally controlled)
Input pads can only be read and report the digital value (high or low) present on the pad at the
read time.
Output pads can only be written to set the value of the pad or queried.
An alternate function pad is internally controlled by the CE910-DUAL firmware and acts
depending on the function implemented.
The following GPIOs are available on the CE910-DUAL.
Pin Signal I/O Function
Drive Strength
Type
C8
GPIO_01 I/O Configurable GPIO 2 mA 1.8V
C9
GPIO_02 I/O Configurable GPIO 2 mA 1.8V
C10
GPIO_03 I/O Configurable GPIO 2 mA 1.8V
C11
GPIO_04 I/O Configurable GPIO 2 mA 1.8V
B14
GPIO_05 I/O Configurable GPIO 2 mA 1.8V
C12
GPIO_06 I/O Configurable GPIO 2 mA 1.8V
C13
GPIO_07 I/O Configurable GPIO 2 mA 1.8V
K15
GPIO_08 I/O Configurable GPIO 2 mA 1.8V
L15
GPIO_09 I/O Configurable GPIO 2 mA 1.8V
G15
GPIO_10 I/O Configurable GPIO 2 mA 1.8V