User's Manual

CE910-DUAL Hardware User Guide
1vv0301010 Rev .0 – 2012-07-10
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 52 of 63
12.3. Recommended foot print for the application
144 pins
< Top View >
In order to easily rework the CE910-DUAL it is suggested to consider having a 1.5 mm
placement inhibit area around the module on the application.
It is also suggested, as a common rule for an SMT component, to avoid having a mechanical
part of the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure) must be clear
from signal or ground paths.