User's Manual
Table Of Contents
- GC864 QUAD V2andGC864 DUAL V2Hardware User Guide
- APPLICABILITY TABLE
- 1 Introduction
- 2. Overview
- 3. GC864 Mechanical Dimensions
- 4. GC864-QUAD V2 / GC864-DUAL V2 Module Connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic Level Specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic Levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Magnetic Buzzer Concepts
- 11.9. Using the Temperature Monitor Function
- 11.10. Indication of Network Service Availability
- 11.11. RTC Bypass Out
- 11.12. DAC Converter
- 11.13. ADC Converter
- 12. Assembly the GC864-QUAD V2 / GC864-DUAL V2 on the Board
- 13. Packing System
- 14. Conformity Assessment Issues
GC864 Hardware User Guide
1vv0300874 Rev.0 – 2010-01-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 16 of 64
NOTE:
RTS must be connected to the GND (on the module side) if flow control is not used.
NOTE:
If not used, almost all pins must be left disconnected. The only exceptions are the
following pins:
Pin Signal Function
1 VBATT Main power supply
2 VBATT Main power supply
3 VBATT Main power supply
4 VBATT Main power supply
5 GND Ground
6 GND Ground
7 GND Ground
46 GND Ground
25 C103/TXD Serial data input (TXD) from DTE
26 C104/RXD Serial data output to DTE
31 C105/RTS Input for Request to send signal (RTS) from DTE
53 ON/OFF* Input command for switching power ON or OFF (toggle command).
54 RESET* Reset input
23 RX_TRACE RX Data for debug monitor
24 TX_TRACE TX Data for debug monitor
47 SERVICE SERVICE connection
4.1.1. GC864-QUAD V2 / GC864-DUAL V2 Antenna Connector
The GC864-QUAD V2 / GC864-DUAL V2 module is equipped with a 50 RF connector
from Murata, GSC type P/N MM9329-2700B.
The counterpart suitable is Murata MXTK92 Type or MXTK88 Type.
Moreover, the GC864-QUAD V2 / GC864-DUAL V2 has the antenna pads on the back
side of the PCB. This allows the manual soldering of the coaxial cable directly on the
back side of the PCB. However, the soldering is not an advisable solution for a
reliable connection of the antenna.