User's Manual

GC864 Hardware User Guide
1vv0300874 Rev.0 – 2010-01-25
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved. Page 7 of 64
1.4. Document Organization
This document contains the following chapters:
Chapter 1: “Introduction”
provides a scope for this document, target audience,
contact and support information, and text conventions.
Chapter 2: “Overview”
provides an overview of the document.
Chapter 3: “GC864-QUAD V2 / GC864-DUAL V2 Mechanical Dimensions”
Chapter 4: “GC864-QUAD V2 / GC864-DUAL V2 Module Connections”
deals with the
pin out configuration and layout.
Chapter 5: “Hardware Commands”
How to control the module via hardware.
Chapter 6: “Power supply”
Power supply requirements and general design rules.
Chapter 7: “Antenna”
The antenna connection and board layout design are the most
important parts in the full product design
Chapter 8: “Logic Level specifications”
Specific values adopted in the implementation
of logic levels for this module.
Chapter 9: “Serial ports”
The serial port on the Telit GC864 is the core of the
interface between the module and OEM hardware
Chapter 10: “Audio Section overview”
Refers to the audio blocks of the Base Band
Chip of the GC864 Telit Modules.
Chapter 11: “General Purpose I/O”
How the general purpose I/O pads can be
configured.
Chapter 12 “DAC and ADC Section”
Deals with these two kind of converters.
Chapter 13: “Mounting the GC864-QUAD V2 / GC864-DUAL V2 on the application
board” Recommendations and specifics on how to mount the module on the user’s
board.