User's Manual

GE865 Hardware User Guide
1vv0300799 Rev.6 - 04/06/09
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 9 of 58
NOTE: RESERVED pins must not be connected
NOTE: If not used, almost all pins should be left disconnected. The only exceptions are the following
pins:
pin
signal
F1,F2,F3
VBATT &
VBATT_PA
G1, C2, C7, E5, E7, G5, G4,
G3, H3, H6
GND
B1
ON/OFF*
A3
TXD
C1
RESET*
A4
RXD
A1
RTS
1
D1
TXD_AUX
E1
RXD_AUX
H1
Service
1
RTS should be connected to the GND ( on the module side) if flow control is not used