User's Manual

3
Indicators
Theindicatorshavedifferentstatesfordifferent
activity.Theindicatorsareactiveonlyifthe
powerison.
Power indicator
• Green, solid Batteryischarged.remotecontrol
isreadytouse.
• Green, blinking fast Batteryischarging.(See
“Tochargethebattery”onpage 3.)
• Green, blinking slowly Thetemperatureistoo
highorlow.(See“Temperatureandhumidity
limits”onpage 12.)
• Green, blinking very fast Batteryneedstobe
replaced.(See“Specifications”onpage 12.)
• Green and yellow, blinking alternately Battery
ischarginginpowersave
mode.
• Yellow, blinking Batteryislow.
• Yellow, solid remotecontrolisinpowersave
mode.
Microphone indicator
•Solid Microphoneisconnected.
• Blinking remotecontrolisintraining.(See“To
traintheremotecontrol”onpage 6.)
Bluetooth indicator
•Solid remotecontrolisconnectedby
Bluetoothtechnology
•Blinking fast remotecontrolistryingto
establishaconnectionbyBluetooth
technology.
• Blinking slowlyremotecontrolissearching for
Bluetoothdevices.(See“Toconnectthe
SonoRemotecontrol”onpage 5.)
USB indicator
• Solid remotecontrolisconnectedbyUSB
cable.
Turning on power and charging the
battery
Beforeusingtheremotecontrol,makesurethat
thebatteryischarged.
Youcanchargeoneremotecontrolwhileusing
anotherthatisconnectedbyBluetooth
technology.
Thebatteryisnearlyfullafterthreehoursof
chargingalthoughthepowerindicatormayblink
foruptofivehoursuntilthebatteryis
full.
To turn the remote control on or off
 Pressthepowerswitch .
SeeFigure 1andFigure 2onpage 2.
To charge the battery
1 ConnecttheultrasoundsystemtoACpower.
2 Turnontheultrasoundsystemandtheremote
control.
3 ConnecttheremotecontrolbyUSBcable.(See
“ToconnectbyUSBcable”onpage 4.)Usea
USBportthatisonthesystem,notonadock.
Note: Ifyouconnecttoadockinstead
oftothe
systemandifthesystementerspowersavemode,
theremotecontroldoesnotcharge.
TheultrasoundsystemignoresthePowerDelay
settingforthreehours,allowingthebatteryto
charge.Ifthesystementerspowersavemode,the
batterycontinuestocharge.Ifthesystemturns
off,
thebatterydoesnotcharge.
Power save mode
Theremotecontrolbeepsthreewarningbeeps
andenterspowersavemodeafterthefollowing
periodofinactivity:
• (Microphoneconnected)15 minuteswithouta
voicecommand
• (Microphonedisconnected)5minutes
withoutabuttonpress
Allindicatorsbutthepowerindicatorturnoff.