User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
- 12 History
BlueMod+S/AI
www.stollmann.de Page 42 of 52
8.2.2 FCC Statement
This device complies with 47 CFR Part 2 and Part 15 of the FCC Rules and with.
Operation is subject to the following two conditions:
(1) this device my not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
8.2.3 FCC Caution
Warning: Changes or modifications made to this equipment not expressly approved by Stollmann
Entwicklungs- und Vertriebs- GmbH may void the FCC authorization to operate this equipment.
8.2.4 FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
8.2.5 FCC RF-exposure Statement
The BlueMod+S/AI complies with the FCC/IC RF radiation exposure limits set forth for an
uncontrolled environment.
The output power is < 10mW EIRP and therefore according to “FCC KDB 447498 D01 General RF
Exposure Guidance v05” Appendix A, table “SAR Exclusion Threshold”, excluded from SAR testing
for test separation distances ≥ 5mm and if it is not used in co-locations with other antennas. If the
product implementing the BlueMod+S/AI has other antennas in co-location or separation distances
< 5mm an FCC TCB should be asked for a Class II Permissive Change.