User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 55 of 65
8.3 IC Compliance
The BlueMod+SR/AI has been tested to fulfill the IC requirements. Test reports RSS-210 of
Industry Canada are available on request. Grants of the Full Modular Approval will be shown
below.
For selling products implementing the BlueMod+SR/AP in Canada you’ll have to apply for a Class
II Permissive Change from the IC authorities. Depending on antenna gain and other factors the IC
TCB will issue a reduced test plan for re-testing. Stollmann can assist customers with conducting
this procedure on request. Especially the test plan reduction and cost optimization may be items
worth to look at.
8.3.1 IC Grant
tbd