User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 57 of 65
8.3.5 IC Labeling Requirements for the End Product
Any end product integrating the BlueMod+SR/AI or /AP must be labeled with at least the following
information:
This device contains transmitter with
FCC ID: RFRMSR
IC: 4957A-MSR
8.3.6 IC Label Information BlueMod+SR
The BlueMod+SR shows no IC-ID on the product label, because there is no space available. IC
allows on request to state the IC-ID in the product manual. This product has been granted to do so.
The IC-ID is: 4957A-MSR