User's Manual

BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 64 of 65
History
Version Release Date By Change description
r02 04.02.2013 MW/JW First preliminary release
r03 21.02.2013 MW/GJ
GJ
JW
FH
signal naming conventions harmonized
signals in tables re-sorted
corrected some typos
updated dimension drawing (with new antenna)
added land pattern drawing
renamed chapter “Restricted Area” into “Placement Recommendation” and
replaced text with drawing
Figure 10 “Pin Numbering” added
Added current consumption for standby mode
Chapter 1 Introduction revised
r04d01 22.02.2013
06.03.2013
19.04.2013 ff.
JW
MW
Spelling and formatting
Chapter 3, Application Examples added to several sub chapters
Chapter 3.1 Power Supply, requirements lowered
Chapter 3.3 allowed to use series resistor to connect external low-active reset
Chapter 3.5 Serial Interface updated, UICP included
Chapter 3.6 renamed to GPIO Interface
Chapter 3.10 minor changes in text
Enhanced chapter 3.13 Pin Strapped System Memory Boot Mode Invocation
New chapter 3.15 Serial Wire Interface
Chapter 4.2 Pin Description, tables updated and corrected, removed signals
“/BT-CONNECTED” and “STM32-WAKEUP”
New chapter 4.3 Handling of unused Signals
Chapter 5.6 Power Consumption Tables updated
Chapter 5.7 RF parameter updated
Chapter 5.7.5 Antenna Gain and Radio Pattern updated
Chapter 6.3 updated
New chapter 7 Application Diagram