FN980m TLB HW Design Guide r0

HW Design Guide Template
1VV0301651 Rev. 0 Page 16 of 25 2020-02-28
RF Antenna For RF antenna, connect antennas to the 4 antenna ports
ANT0, ANT1, ANT2 and ANT3.
GNSS Antenna For GNSS antenna, you can use ANT4.
*USB Type-C FN980m supports USB 3.1 GEN2 interface.
USB connector of Telit Evaluation Board does not support 10
Gbit/s.
Must use USB Type-C connector which is located in TLB of
FN980m.
AT Commands /
DATA Port
Connect the USB Type-C cable to a Windows PC or Linux PC
only after you install necessary drivers. Refer to software user
guide for details.