Installation Instructions

SkyBitz SkyHub & SkyCamera Installation 2
SkyHub Tracking System Installation
• Use the SkyHub bracket as a template to mark the bracket location, and the 3 VHB tape
locations on the wall
• Prep the trailer wall for the 3 VHB tape mounting surface locations
o Clean with IPA solution
o Abrade lightly with Scotch-Brite pad
o Clean again with IPA solution
o Prime with 3M Primer 94 and wait at least 3 minutes
• Remove the liner from the 3 VHB tape locations on the bracket, place the bracket onto the
mounting location on the trailer wall, and firmly press it onto the wall
• Use the rivet holes in the bracket as a guide and drill six 1/8-inch holes in the trailer wall
• Secure the bracket to the wall with the six 1/8-Inch sealing rivets
• Orient the SkyHub with the connector on the left for a horizontal install, or with the connector at
the top for a vertical install, and install it on the bracket
• Using a hand driver, secure the SkyHub to the bracket with four, 10-32 tamper proof screws