Installation Instructions

SkyBitz SkyHub & SkyCamera Installation 4
SkyCamera Installation
• Use the SkyCamera bracket as a template to mark the location of the bracket and the 1.75-
inch camera hole
• Drill the 1.75-inch hole for the camera and remove any burrs
• Prep the VHB Tape mounting surface
o Clean with IPA solution
o Abrade lightly with Scotch-Brite pad
o Clean again with IPA solution
o Prime with 3M Primer 94 and wait at least 3 minutes
• Insert the SkyCamera install tool into the hole
• Remove the liner from all 4 pieces of VHB tape on the bracket
• Align the camera hole in the SkyCamera Mounting Bracket with tool, ensure the bracket is
vertical, and press the bracket onto the trailer wall
• Remove the SkyCamera install tool
• Using the bracket as a template, drill the eight 3/16-inch rivet holes in the trailer wall
• Install the eight 3/16-inch rivets