UE866 Product Description [01.2017] 80439ST10671A Rev. 3 – 2017-05-26 Mod. 0809 2017-01 Rev.
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE NOTICE While reasonable efforts have been made to assure the accuracy of this document, Telit assumes no liability resulting from any inaccuracies or omissions in this document, or from use of the information obtained herein. The information in this document has been carefully checked and is believed to be reliable. However, no responsibility is assumed for inaccuracies or omissions.
USAGE AND DISCLOSURE RESTRICTIONS I. License Agreements The software described in this document is the property of Telit and its licensors. It is furnished by express license agreement only and may be used only in accordance with the terms of such an agreement. II. Copyrighted Materials Software and documentation are copyrighted materials. Making unauthorized copies is prohibited by law.
APPLICABILITY TABLE PRODUCTS UE866-N3G UE866-EU 80439ST10671A Rev.
CONTENTS NOTICE ..................................................................................................... 2 COPYRIGHTS ................................................................................................ 2 COMPUTER SOFTWARE COPYRIGHTS ...................................................... 2 USAGE AND DISCLOSURE RESTRICTIONS ............................................... 3 I. License Agreements ..................................................................... 3 II.
Input and Outputs ....................................................................... 17 3.8.1. General Purpose I/Os ................................................................. 17 3.8.2. Power on monitor (PWR_MON) .................................................. 17 3.8.3. Power on/off control (ON_OFF) .................................................. 17 3.8.4. Auxiliary power output for accessory (VAUX) .............................. 17 3.8.5. SIM Reader ...............................
1. INTRODUCTION Scope Scope of this document is to give an overview of the Telit UE866 module, which can support WCDMA/HSPA with data/voice capabilities. Audience This document is intended for customers who are evaluating the UE866 product. Contact Information, Support For general contact, technical support services, technical questions and report documentation errors contact Telit Technical Support at: TS-EMEA@telit.com TS-AMERICAS@telit.com TS-APAC@telit.com Alternatively, use: http://www.
Text Conventions Danger – This information MUST be followed or catastrophic equipment failure or bodily injury may occur. Caution or Warning – Alerts the user to important points about integrating the module, if these points are not followed, the module and end user equipment may fail or malfunction. Tip or Information – Provides advice and suggestions that may be useful when integrating the module. All dates are in ISO 8601 format, i.e. YYYY-MM-DD.
2. OVERVIEW The UE866 is the smallest module in Telit’s 3G portfolio. With its ultra compact 15 x 25 mm LGA footprint, it is designed for applications with severe space constraints. It is a dual band UMTS | HSPA communication product based on the market’s latest 3G core which allows integrators to count on availability for even the longest lifecycle applications. It is highly recommended for new designs particularly for deployments where the 2G networks are no longer required.
Product variants The following table describes the band combination of the UE866 variants. The UE866-N3G variant is suitable for the North American market in a dual band 3G-only configuration.
Interfaces I/O ports including multi-functional I/Os I2S for digital audio interface USB 2.0 HS 2 UART 1 SPI 1 I2C 1.
Approvals Fully type approved confirming with R&TTE directive CE & GCF FCC, IC, PTCRB AT&T REACH & RoHS 80439ST10671A Rev.
3. GENERAL PRODUCT DESCRIPTION Dimensions and 2D mechanical drawing UE866 has a LGA package, with 77 pads. The overall dimensions of UE866 are: Length: 25.0 mm Width: 15.0 mm Thickness: 2.2 mm 80439ST10671A Rev.
Environmental requirements 3.2.1. Temperature range –40°C ~ +85°C Operating Temperature Range 3.2.2. RoHS compliance As a part of Telit corporate policy of environmental protection, the UE866 complies with the RoHS (Restriction of Hazardous Substances) directive of the European Union (EU directive 2011/65/EU). 80439ST10671A Rev.
Operating Frequency The operating frequencies in GSM850, EGSM900, DCS1800, PCS1900, WCDMA modes are compliant to the 3GPP and WCDMA specifications. Mode GSM850 Freq. TX (MHz) Freq. RX (MHz) Channels TX – RX offset 824.2 ~ 848.8 869.2 ~ 893.8 128 ~ 251 45 MHz 890.0 ~ 914.8 935.0 ~ 959.8 0 ~ 124 45 MHz 880.2 ~ 889.8 925.2 ~ 934.8 975 ~ 1023 45 MHz DCS1800 1710.2 ~ 1784.8 1805.2 ~ 1879.8 512 ~ 885 95MHz PCS1900 1850.2 ~ 1909.8 1930.2 ~ 1989.8 512 ~ 810 80MHz WCDMA850 (band V) 826.
Transmitter output power The UE866 transceiver output of GSM/GPRS mode in 850/900MHz bands are class 4 in accordance with the specifications which determine the nominal 2W peak RF power (+33dBm) on 50ohm. In the 1800/1900MHz bands are class 1 in accordance with the specification which determines the nominal 1W peak RF power (+30dBm) on 50ohm. The UE866 transceiver output of EDGE mode in 850/900MHz bands are class E2 in accordance with the specifications which determine the nominal 0.
Power consumption The UE866 power consumptions are described in the following table Mode Average (mA) AT+CFUN=5 1.6 mA Mode Description Disabled TX and RX; DRX7 WCDMA Voice 175 WCDMA voice call (TX = 10dBm) WCDMA HSDPA (22dBm) 490 WCDMA data call (Cat 8, TX = 22dBm) Logic level Where not specifically stated, the most of interface circuits work at 1.8V CMOS logic levels. To get more detailed information about the logic level specifications used for UE866, please refer to the Hardware User Guide.
3.8.6. Converters The UE866 family has 1 ADC and 1DAC. 3.8.7. Audio Interface A Digital Audio bus is available. 3.8.8. Serial ports Two serial ports are available. 3.8.9. Full RS232-C Auxiliary serial port (RX/TX only) USB port The USB2.0 High Speed has a clock rate of 480MHz 3.8.10. User Interface The user interface is managed by AT commands according to ITU-T V.250, 3GPP 27.007 and 27.005 specifications. Please refer to the AT command User Guide for complete details. Features 3.9.1.
3.9.4. Data Transmission capabilities The UE866 supports: 3.9.5. HSPA: D/L up to 7.2Mbps, U/L up to 5.76Mbps Asynchronous non-transparent CSD up to 9.6kbps for GSM, 14.4kbps for WCDMA EDGE Class 10 for NAx variants and Class 33 for EUx variants Coding scheme 1 to 4 (GPRS) & Modulation Coding scheme 1 to 9 (EDGE) Local security management The local security management can be done with the lock of Universal Subscriber Identity Module (USIM), and the security code will be requested at power-up.
3.9.11.
4. EVALUATION KIT In order to assist the customer in the development of the application, Telit offers the EVK2 Evaluation Kit that can be ordered separately. The EVK2 has a SIM card holder, the RS 232 serial port level translator, a direct UART connection, audio and antenna connector. The EVK2 provides a fully functional solution for a complete data or phone application. The standard serial RS232 9 pin connector placed on the Evaluation Kit allows the connection of the EVK2 system with a PC or other DTE.
5. AT COMMANDS The UE866 can be driven via the serial and USB interface using the standard AT commands. The modules are compliant with: 1. Hayes standard AT command set, in order to maintain the compatibility with existing S/W programs. 2. 3GPP TS 27.007 specific AT command and WCDMA/GPRS specific commands. 3. 3GPP TS 27.005 specific AT commands for SMS (Short Message Service) and CBS (Cell Broadcast Service) Moreover, the modules support also Telit proprietary AT commands for special purposes.
6. SAFETY RECOMMENDATIONS READ CAREFULLY Be sure the use of this product is allowed in the country and in the environment required. The use of this product may be dangerous and has to be avoided in the following areas: Where it can interfere with other electronic devices in environments such as hospitals, airports, aircrafts, etc. Where there is risk of explosion such as gasoline stations, oil refineries, etc.
7. CONFORMITY ASSESSMENT ISSUES 80439ST10671A Rev.
80439ST10671A Rev.
RED Notified Body statement of Opinion 80439ST10671A Rev.
80439ST10671A Rev.
FCC certificate 80439ST10671A Rev.
80439ST10671A Rev.
IC certificates 80439ST10671A Rev.
8.
Description MT Mobile Terminated OEM Other Equipment Manufacturer PCB Printed Circuit Board PCM Pulse Code Modulation PDA Personal Digital Assistant PDU Protocol Data Unit PIN Personal Identification Number POS Point Of Sales PWM Pulse Width Modulation RF Radio Frequency RoHS Restriction of Hazardous Substances RTC Real Time Clock SAIC Single Antenna Interface Cancellation SIM Subscriber Identity Module SMD Surface Mounted Device SMS Short Message Service S/W Software TBD
9. DOCUMENT HISTORY Revision Date Changes 0 2014-12-05 First issue 1 2015-04-20 Removed the EU variant; update consumption figures 2 2017-03-01 Updated certificates for new SW release Added new product UE866EU 3 2017-05-26 2017 Template Applied Updated RED certificates Updated SAFETY RECOMMENDATIONS 80439ST10671A Rev.
[01.2017] Mod. 0809 2017-01 Rev.
