User's Manual
Table Of Contents
- SS5200 Thermostat
- In This Training Guide
- What is a “SmartSystem”?
- How Does it Work?
- What Happens While a Guest is in the Room?
- How Does the Sensor Know When the Room is Empty?
- If You Walk Into a Room That Feels Too Warm or Too Cool…
- Buttons on the Thermostat
- Pictures on the Thermostat
- Note to Housekeeping and Front Desk
- Slide Number 11
- When Housekeeping Finds a Problem in a Room
- Too Hot or Too Cold
- Temperature Won’t Go Lower/Higher
- Thermostat is Clicking
- Thermostat Won’t Respond
- What Happens While a Guest is in the Room?
- Installing a New Sensor
- Sensor Installation Steps - Overview
- Important Note About Installing a New Sensor
- Remove the Failed or Vandalized Sensor
- Insert Batteries
- Connect New Sensor to the Base
- After the Sensor is Installed
- Installing a New Thermostat
- Thermostat Installation Steps - Overview
- Important Note About Installing a New Thermostat
- Unlock the Thermostat
- Remove Failed or Vandalized Thermostat
- Attach New Thermostat to Base Plate
- After the Thermostat is Installed
- Link the Sensor to the Thermostat
- Unlock the Thermostat
- The Hidden Buttons
- Pressing the Buttons
- Unlock the Buttons(NOTE: New Thermostat Will Already Have Unlocked Buttons)
- Erase Old Sensors From Thermostat’s Memory
- Put the Thermostat into “Learn” Mode
- Establish Radio Link
- Check the Signal Strength
- Double Check Radio Link
- Lock the Buttons
- Lock the Thermostat Cover
- Troubleshooting
- Equipment Maintenance
- What Does the Flashing Wrench Mean?
- Low Batteries?
- Flashing Wrench Problem Solved
- If the Screen Went Completely Blank, Displays an “Inkblot” on the Front or Thermostat Has Been Crushed or Stolen
- If a Button is “Stuck”
- What if All of the Symbols are Starting to Appear on the Screen?
- What if the Thermostat is Clicking Loudly?
- Need Help?
- Product Return Procedures
- Thank you for your cooperation.
Put the Thermostat into
“Learn”
Mode
Press the “%”
three times in a
row, the screen should show “00”.
Press the UP arrow until you
reach “02”.
Press “%”
once.
The screen should now show “-0”.
This means the thermostat is now
in “Learn”
mode and ready to
learn the sensor.
%
Press three times.
Press to go to “02”.
%
Press once.
Screen shows ready to learn.