User's Manual

Table Of Contents

6.70.104 SS2000 / SS2200 Association Procedures 5/2010

Step One – Power the Thermostat

1. Apply Power to the unit

2. Set the Thermostat to “Learn” mode:

a. Lift the front cover to expose the front panel buttons.

b. Push the % button three times in a row.

c. The display will read 00

d. Press the Up Arrow until the display reads 02, then push the % button again. “2”

represents the command to associate Sensors.

e. The display will change to Learn Mode, showing -0 then any number from 0 to 9.

Figure 2: Thermostat in "Learn Mode"

f. The Thermostat will remain in Learn Mode for approximately 90 seconds.

Step Two – Initiate the Association

5. While the Thermostat remains in Learn Mode, Poke the sensor.

6. The Thermostat will display a character plus a number, as seen below. The number

indicates the relative strength of the RF signal from the Sensor, on a scale of 0

(lowest) to 9 (highest).

Confidential – Information contained in this document is considered proprietary and confidential, and is intended for the internal

use of Telkonet, Inc. our contracted Partners and VARs, and customers. This content is protected by all applicable copyright