User's Manual

EcoWave
Installation
Guide
Telkonet,
Inc.
Wiring t
he EcoInsight/EcoSource
10200 W. Innovation Dr., Ste. 300
Revision 9
Milwaukee
, WI 53226
Page
5
(800) 380
-
9640
www.telkonet.com
17. Starting at the bottom of the terminal block and working up, use a Phillips screwdriver to secure each
of the HVAC wires into the appropriate pins on the terminal block. See Figure 2.
Figure 2: Connecting Wiring from Bottom to Top
18. If any wires are left unused, cap off the wire using a wire nut or electrical tape.
19. Verify each wire is secure by gently tugging on it.
20. Verify the completed wiring looks similar to Figure 3.
Figure 3: EcoInsight/EcoSource Backplate Wired to HVAC Unit
21. Hook the EcoInsight/EcoSource to the hinges on the right-hand side of the backplate.
22. Gently swing the EcoInsight/EcoSource closed onto the backplate until it snaps into place. If you
encounter resistance, check to make sure no wires are pinched between components.
23. Inside the PTAC, verify the GFI (if so equipped) has not been tripped.
24. Verify that the PTAC has been set to Class II (remote thermostat) operation (if applicable). Consult
PTAC manual for proper procedure.
25. Reinsert and tighten the security screw on the EcoInsight/EcoSource.
26. Remove all lockouts or tags from the circuit breaker.
27. Return the electrical circuit to operation.
28. Verify the display on the EcoInsight indicates the state of the device; verify the LED on the EcoSource
is lit solid green.