User's Manual

EcoWave
Installation
Guide
Telkonet,
Inc.
Configuration
10200 W. Innovation Dr., Ste. 300
Revision 9
Milwaukee
, WI 53226
Page
7
(800) 380
-
9640
www.telkonet.com
Configuration
Join the EcoInsight/EcoSource to the EcoConnect
Enter the join codes on each device. The PAN and Channel will be set automatically.
Required Equipment
Hardware
• An EcoCommander or EcoCommander Pro
• An EcoConnect
• An EcoInsight/EcoSource that has been wired
• Unbent paperclip or pen
Join Process
1. Verify the EcoCommander or EcoCommander Pro is powered.
2. Verify the EcoConnect is powered.
3. Verify the EcoConnect is connected to the EcoCommander or EcoCommander Pro.
4. Verify the EcoInsight/EcoSource is powered.
5. Use a paperclip or pen and Figure 4 below to enter the join code on the EcoConnect.
Figure 4: EcoConnect and Join Code
6. Verify the LED on the front of the EcoConnect rapidly blinks green.
7. If your device is an EcoSource, proceed to the next step. If your device is an EcoInsight, proceed to
Step 13.
8. Use a paperclip or pen and Figure 5 below to enter the join code on the EcoSource.