User's Manual

EcoSense+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
EcoSense+ Introduction Waukesha, WI 53186
Revision 2 [phone]
Page 4 www.telkonet.com
EcoSense+ Introduction
The EcoSense+ contains a PIR that detects both
motion and heat to determine occupancy. It
communicates information wirelessly to the
EcoSmart thermostat.
Remove the cover you’ll discover that the sensor is
directional. Aim it in the appropriate direction to
detect heat and motion. It is important to install
the device in the optimal location and to aim the
PIR correctly.
EcoSensevsEcoSense+:Installation
Differences
If you’re accustomed to installing our traditional
EcoSense, you’ll find we’ve made some installation
changes:
*NEW* EcoSense+
Traditional EcoSense
May need to install in different location in the room
than traditional EcoSense "We recommend mounting
the EcoSense+ on the wall next to the bed, pointed down
near the pillows of the bed. "Details on page 6.
Old location rules apply.
Before mounting, ensure backplate is rotated to the
correct position so that PIR is facing the appropriate
direction.
Once installation location is determined, backplate
can be rotated in any direction before mounting to
surface.
Adjust the PIR direction (between 40-90°). PIR is stationary, therefore no need to adjust
direction.
Zone of Detection is elliptical and narrower (smooshed
cone).
Zone of detection is circular and wider.
Joining/Binding “tab” can be pressed with finger,
after cover is put on.
Must use paperclip to press the Joining/Binding
button.
Join network and bind to thermostat in one process. Bind only, no need to join to network.
EcoSense+ joins the EcoSmart network, therefore it
takes up a slot on the coordinator and counts toward
the maximum devices per coordinator (65).
Does not count toward maximum devices per
coordinator.