User's Manual

EcoSource High Voltage Installation
Figure 11: Metal Pins
Step 20 Return the electrical circuit to operation. Remove all lockouts or tags from the circuit breaker
and enable any disconnects.
Step 21 Verify the EcoSource thermostat display is active.
Step 22 Test all components to make sure that you can engage both the heat and air conditioning, and
all supported fan settings (high, low, etc.). Wiring is complete.
Step 23 Once the thermostat has been snapped onto the backplate, use a hex wrench to insert the
safety screw.
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
EcoSour ce Waukesha, WI 53186
Revision 2 [phone]
Page 13 www.telkonet.com