User's Manual

EcoTouch Installation
Installation
EcoTouch can accept 24VAC or 12-14VDC on J2.
Use wire harnesses with red and black stripped wires and JARD J4021F transformers, both provided
by Telkonet. (Exceptions may apply in certain circumstances.)
Step 1 Review table on page 25 to determine where the EcoTouch will be mounted.
Step 2 Remove the security screw from the EcoTouch (see Figure 25).
Figure 25-Security Screw
Step 3 Separate the backplate from the EcoTouch by sliding the backplate to the right and the front
plate to the left (approximately ¼ inch), as shown in Figure 26.
Figure 26: Slide Top Left, Bottom Right
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
EcoTouch Waukesha, WI 53186
Revision 2 [phone]
Page 26 www.telkonet.com