Installation Manual

Titel Reg. Nr. Date Author Revision
Installation Manual MCG TQ377 TQ-18-496 2019-05-29 Erik Ljung p1k
If the unit is to be connected to CAN-BUS, place the unit as close as possible to connection
point. Mount the unit where the temperature is lower than 60℃.
Drill one 5,5mm hole at the machine and screw the unit using one screw to the machine, use a
force of 3Nm (max 3,6Nm).
If the four holes shall be used for mounting, drill four 4,5mm hole at size 58*90mm and use M4
screws to secure the unit on the machine, use a force of 2Nm (max 3,6Nm).
If the optional magnetic kit is used, screw these four magnets to the unit and snap the unit on to
the machine at a suitable place.
If the optional fixation plate is used, screw that to the unit and screw the plate (and unit) to the
machine.
Strap the cables on the machine to where they shall be connected.
TelliQ AB
Glasbruksgatan 1, 732 31 Arboga, Sweden
Tel: [phone], www.oem.telliq.com
Page:5