User's Manual
1
Copyright © 2002 by manufacturer. All rights reserved.
Ÿ No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as
translation, transformation, or adaptation) without written permission from the copyright owner.
Ÿ All the other trademarks and registered trademarks are the property of their respective owners.
Statement of Conditions
Ÿ
The content described in this manual may be improved or changed at any time and it is subject to be changed without notice.
Ÿ Manufacturer assumes no responsibility for errors contained herein or for direct, indirect, special, incidental or consequential
damages with the furnishing, performance, or use of this manual or equipment supplied with it, even if manufacturer of its suppliers
have been advised of the possibility of such damages.
Electronic Emission Notices
Ÿ This device complies with Part 15 of the FCC Rules and Canada RSS-210. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device will accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Statement
Ÿ This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user need to correct the interference at his area. If the
equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following
measures:
Ÿ Plug the equipment into an outlet that is on a different circuit from the television or radio.
Ÿ Change the direction of the television or radio antenna until the interference disappears.
Ÿ Move the equipment to one side or the other of the television or radio.
Ÿ Move the equipment farther away from the television or radio.
Ÿ
To assure continued compliance, any changes or modifications not expressly approved by manufacturer could void the user’s
authority to operate the equipment.
FCC Radiation Exposure Statement
Ÿ
This device and its antennas must operate with a separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter. End users must be provided with specific operating instructions
for satisfying RF exposure compliance.
Ÿ
Ÿ This product has been certified in Canada, France, Germany, Italy, Spain, Sweden, Taiwan, UK, and US.
LIMITED WARRANTY
Ÿ This product is warranted by manufacturer to be free from defects in material and workmanship for one (1) year from the date of
purchase.
Ÿ During this period if this product is found to be defective in material or workmanship, manufacturer or one of its authorized service
facilities will at its option either repair or replace this product without charge, subject to the following conditions, limitations and
exclusions:
1. This warranty extends to the original consumer purchaser only and is not assignable or transferable.