User's Manual

Step 2: Confirm the remote IP

If you know the AP2’ s IP address, then type it in the “Remote IP” blank. If you do not

know the AP2’ s IP address, then click Rescan. Wait for few seconds, and select the right

AP name from the pull-down menu.

Step 3: Click “Start” button

When you click the “Start” button, the RSSTool will send message to the AP2. You can

adjust the AP2’ s antenna until AP2’ s Led of RSS bright.

Step 4: Click “Abort” button

If you have adjusted the AP2’ s antenna, you can stop this tool.

Step 5: Repeat the Step 1 ~ 4 at LAN2’ s PC or NB

When you finish the step 5, you will get the best angle of antennas. Then AP1 and AP2

can communicate with the best quality.

Note: When RSSTool is running, you can’ t run SNMP Manager at the same time.