User's Manual

Wireless LAN 11g Access Point Users Manual
Version 0.11
14
2.3 The AP’s Rear Panel
The rear panel contains the port connections described below (Figure 2-1):
Figure 2-1 Rear Panel
Items Description
Power Inlet Connect the included power adapter to this inlet.
Warning: Using the wrong type of power adapter may damage your AP.
LAN Port Connect device (such as a PC, hub, switch or router) on your local area
network to this port.
Reset Button Press the button (10 second) to restore the default factory settings.
Wireless antenna Rotate antenna to the best position for more effective coverage.
2.4 System Requirement
Your system should meet the following requirements to install the AP successfully.
A Cable/DSL modem/router with 10/100 Mbps Ethernet port or a 10/100 Mbps LAN device such
as a hub or switch.
A category 5 UTP Ethernet cable with RJ-45 connectors and enough length from the location of
AP to the modem, router, hub or switch.
An A/C power outlet (100~240V, 50~60Hz) or device with PSE (refer to 2.8) close to the location
of AP
Microsoft Internet Explorer 5.00.3700.1000 or later (Netscape V6/7 or later) web browser for
configuration.
One computer with TCP/IP protocol installed.
802.11g/b compliant adaptors.