User's Manual

Wireless LAN 11g Access Point User’s Manual
Version 0.11
15
2.5 Default Settings
The following table shows The AP default settings.
2.6 Connect the Power Adapter
Plug the power adapter into the power inlet on The AP, and the other end into a power outlet. Check
the Power LED on the front panel to make sure it is on. Warning: Use only power adapter supplied
with The AP; otherwise, The AP may be damaged.
2.7 Connect to a Network
Use twisted-pair RJ-45 connector Ethernet cable to connect the LAN ports to a cable/DSL modem,
Ethernet hub, switch or router. If it is correctly connected, the LAN LED will be on.
Items Default Setting
IP Address
192.168.1.250
User Name/Password
admin/admin
IP Subnet Mask
255.255.255.0
SSID
ap11g
RF channel
6
Mode
11b+g
WEP
Disabled