User's Manual

Wireless LAN 11g Access Point User’s Manual
Version 0.11
17
3. Configuration
START UP & LOGIN
In order to configure The AP, you must use your web browser and manually input http://192.168.1.250
into the Address box and press Enter. To start configure The AP, you must login as “admin” in the
User Name box. And input password “admin” on the password section.
Once you have logged-in as administrator, it is a good idea to change the administrator password to
ensure a secure protection to The AP. The Security Settings section described later in this manual
describes how to change the password.
Once you have input the correct password and logged-in, the screen will change to the Setup page
screen.
TURN ON POWER SUPPLY
Quick power cycle can caused system corruption. When power on, be careful not to shu
t
down in about 5 seconds, because data is writing to the flash.
Before Starting
The default IP address setting for the unit is a class C IP address (192.168.1.250
/
255.255.255.0). Please make sure that the current workstation is following the class C
IP address range, from 192.168.1.1 to 192.168.1.254, refer to Appendix A.