User's Manual

Wireless LAN 11g Access Point User’s Manual
Version 0.11
38
 Make sure that each computer has a unique IP address. And the IP must be in the same subnet
as the AP.
 Make sure that the Link LED is on. If it is not, try a different network cable.
 Check each computer for correct network settings.
c). Wireless Troubleshooting
I can’t access the Wireless AP from a wireless network card
Cause:
 Out of range.
 IP Address is not set correctly.
Resolution:
 Make sure that the Mode, SSID, Channel and encryption settings are set the same on each
wireless adapter.
 Make sure that your computer is within range and free from any strong electrical devices that
may cause interference.
 Check your IP Address to make sure that it is compatible with the Wireless AP.
d). Lost or forgot Administrator password.
 Reset system setting (by holding Reset button down for 10 seconds) into factory default, this
will restore administrator password to admin/admin.
 Re-configure your AP according to your previous setting.
Warning: When you reset the AP device, the configuration settings will also be reset to the factory
default. Make sure you have written down the AP settings for record.