User's Guide

INFORMATION TO USER

Federal Communications Commission Statement

This product has been tested and complies with the specifications for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. The antenna used for this

transmitter must be installed to provide a separation distance of least 20 centimeters from all

persons and must not be operating in conjunction with other antenna or transmitters. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used according to the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which is found by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

．

Reorient or relocate the receiving antenna.

．

Increase the separation between the equipment or device.

．

Connect the equipment to an outlet other than receiver .

．

Consult a dealer or an experienced radio/TV technician for assistance

Notice: The Part 15 radio device operates on a non-interference basis with other devices

operating at this frequency. Any change or modification not expressly approved by the party

responsible could void the user authority to operate the device.

Regulatory

The wireless LAN PCI Adapter must be installed and used in strict accordance with the

manufacturer instructions. This device complies with the following radio frequency and safety

standards.

USA - Federal Communications Commission (FCC)

This device complies with Part 15 of FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference that may cause undesired operation.

Europe - R&TTE Directive

This device complies with the specifications listed below:

．

ETS 301-489 General EMC requirements for Radio equipment.

．

ETS 300-328 Technical requirements for Radio equipment.

．

EN60950 Safety requirements for Radio equipment.

EU Countries not intend for use

The ETSI version of this device is intended for home and office use in Austria, Belgium,

Denmark, Finland, France (with Frequency channel restrictions). Germany, Greece, Ireland,

Italy, Luxembourg, Netherlands, Portugal, Spain, Sweden and United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member states Iceland,

Liechtenstein, Norway and Switzerland.