User's Manual

TWL-C11 TGC PROPRIETARY Rev. 1.0
User’s Manual 12/18/2000
Tellus Group Corporation
4F, No.15, Industry E. Rd. IX, SBIP, Hsinchu, Taiwan, R.O.C.
Tel: [phone] Fax: [phone]
Copyright © 2000 by Tellus Group Corp. All rights reserved.
No part of this documentation may be reproduced in any form or by any means or used to make any derivative
work (such as translation, transformation, or adaptation) without written permission from the copyright owner.
All the other trademarks and registered trademarks are the property of their respective owners.
Statement of Conditions
Tellus Group Corp. may make improvements or changes in the product described in this documentation at any
time. The specifications and information regarding to the product in this manual are subject to change without
notice.
Tellus Group Corp. assumes no responsibility for errors contained herein or for direct, indirect, special, incidental
or consequential damages with the furnishing, performance, or use of this manual or equipment supplied with it,
even if Tellus Group Corp. or its suppliers have been advised of the possibility of such damages.
Electronic Emission Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense. If the
equipment causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
• Turn the television or radio antenna until the interference stops.
• Move the equipment to one side or the other of the television or radio.
• Move the equipment farther away from the television or radio.
• Plug the equipment into an outlet that is on a different circuit from the television or radio.
To assure continued compliance, any changes or modifications not expressly approved by Tellus Group Corp.
could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with the minimum distance between your body and the Antenna as
shown below:
Built-in patch antennas: 20cm (8 inches).