User's Manual

Telnova Technology Co.,Ltd
6
FCC Statement:
NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by ValenceTech Limited may void the
FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Radiofrequency radiation exposure information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Please
see the RF Exposure information. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device should be installed and operated with a minimum distance of 20cm between the antenna and all
persons.
Label requirements:
Contains Transmitter Module FCC ID:
WY9F-3066
Host use instruction:
The module must install and work with a speaker,
The speaker’s manufacturer is Telnova Technology Co., Ltd..
The Host mode name:
MBT300 BLUETOOTH SPEAKER
The Host Brand Name: N/A
FCC RF Exposure Requirement
1. At least 20cm separation distance between the antenna and the user’s body must be maintained at all times.
And must not transmit simultaneously with any other antenna or transmitter, except in accordance with FCC
multi transmitter product procedures.
2. To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation,
the maximum antenna gain including cable loss in a mobile-only exposure condition must not exceed 0dBi in
the 2.4G band.
3. A user manual with the end product must clearly indicate the operating requirements and conditions that must be
observed to ensure compliance with current FCC RF exposure guidelines.