User's Manual

Telnova Technology Co.,Ltd
9
If this module is intended for use in a portable device, you are responsible for separate approval to satisfy the
SAR requirements of FCC Part 2.1093.
The user manual for the end product must include the following information in a prominent location:
This device is granted for use in Mobile only configurations in which the antennas used for this transmitter must
be installed to provide a separation distance of at least 20cm from all person and not be co-located with any
other transmitters except in accordance with FCC and Industry Canada multi-transmitter product procedures.
The end product with an embedded FCC ID: WY9F-3066 Module may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15.
The labeling instructions of finished products refer to following requirements:
A certified modular has the option to use a permanently affixed label, or an electronic label (see Electronic
Labelling below). For a permanently affixed label, the module must be labelled with an FCC ID - Section 2.926
(see Certification (labelling requirements) above). The OEM manual must provide clear instructions explaining
to the OEM the labelling requirements,options and OEM user manual instructions that are required (see next
paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module’ s FCC ID is not visible when
installed in the host, or (2) if the host is marketed so that end users do not have straightforward commonly used
methods for access to remove the module so that the FCC ID of the module is visible; then an additional
permanent label referring to the enclosed module:
ĀContains Tr
ansmitter Module FCC ID: WY9F-3066” or “Contains FCC ID: WY9F-3066” must be used.
The host OEM user manual must also contain clear instructions on how end users can find and/or access the
module and the FCC ID.
Other user manual statements may apply.