User's Manual

22 PB-007726 Rev - A
2005.07.04
Available PT-210M frequencies are selected by clicking on the drop-down list
control and left clicking the desired frequency. The PT-210M unit cannot
transmit on any other frequency other than the specific ones shown.
Note: If both digital and voice transmissions are desired, the user may elect to
transmit on the same or different frequencies.
3.5.6.4 Voice Transmit Count
The Voice Transmit Count establishes the number of times a message will be
transmitted using the synthesized voice format. The count is programmable from
0 to 3. If the Voice Transmit Count is set to 0, the PT-210M will not transmit a
voice message.
Note: If the Voice Transmit Count is greater than 0, and a Tamper detection
occurs, the Tamper event will be transmitted 3 times.
3.5.6.5 Voice Transmit Frequency
The Voice Transmit Frequency is used for transmitting messages in the
synthesized voice format. The PT-210M frequency range is set at the factory and
is displayed following a read of the unit. Available PT-210M frequencies are
selectable by clicking on the drop-down list control and left clicking the desired
frequency. The PT-210M unit cannot transmit on any other frequency other than
the specific ones shown.
Note: If both digital and voice transmissions are desired, the user may elect to
transmit on the same or different frequencies.
3.5.6.6 CTCSS Frequency
When voice transmissions are enabled, the PT-210M supports the addition of a
CTCSS (Continuous Tone Coded Squelch System) tone. To enable CTCSS,
select the desired tone frequency from the drop-down list control. To disable
CTCSS, select “None”.