User's Manual

24 PB-007726 Rev - A
2005.07.04
3.5.7.4 Status 2 Time
This is the time of day at which a Status 2 transmission will occur and is
programmable from 00:01 to 23:59 (hours and minutes).
Note: The Status 2 Time cannot be the same as the On Duty Time, Off Duty
Time, or Status 1 Time.
3.6 Status Bar
The Status Bar displayed at the bottom of the screen provides confirmation and software status
information. The lower left corner is blank until a read is performed. Following a read, the PT-
210M firmware version, day of week, and time of day are displayed.
The selected COM port and an operations progress bar are displayed in the center.
In the lower right corner the following messages may be displayed:
1. Timed out while waiting for PT-210M response 7. Read error: Operation aborted
2. Configuration file load unsuccessful 8. Read completed successfully
3. Configuration file load successful 9. Programming error: Operation aborted
4. Configuration file load canceled 10. Programming complete
5. Configuration file save successful 11. Verification error: Operation aborted.
6. Configuration file save canceled 12. Verification completed successfully
4.0 PT-210 PDA Software
4.1 Using the software
The PT-210M PDA software comes pre-loaded into the PDA-4000 Handheld Programmer and
therefore no installation is required. Turn the unit on by pressing the power button, located in the
lower right-hand corner of the TDS Recon Pocket PC keypad, briefly. Afterwards, a Windows
Pocket PC

desktop screen appears. Tap the
START
button in the upper right-hand corner of
the screen and select EIDS from the drop down list menu. Once the EIDS Product Programmer
begins, select PT-210 from the Product Model menu and tap
OK
to launch the configuration
software.