User's Manual

30 PB-007726 Rev - A
2005.07.04
Note: The menu bar selections at the bottom of the configuration screen are not available
in this operation.
4.5.2 Units
The units section provides the operator with information about the different devices
which have been communicated with by the PDA-4000 programmer within a particular
product model during a particular configuration session. The serial number of the device,
the installed operating system (Firmware) and any factory parameters are listed in the
order in which they were accessed. Various editing features allow enhanced operability.
Tap the Units message text or double-tap the Units contents field to access the
adjustment screen.
When finished, tap OK to return to the configuration screen. Tap Cancel to abort the
process.
Tapping the Help button initiates the Units Section help system. From the menu bar the
operator also has access to the EIDS Help contents and to the TDS Recon help contents.
A Find feature allows the operator to search for a particular item.
Note: The menu bar selections at the bottom of the configuration screen are not available
in this operation.
4.5.3 Sensor Detection
The Sensor Detection section contains configuration items for all of the sensor
acitivities. This is where the individual sensors are enabled or disabled, various
sensitivity settings are adjusted and sensor modes of operation are established. Tap the
Sensor Detection message text or double-tap the Sensor Detection contents field to
access the adjustment screen.
4.5.3.1 Sensor Mode
The sensor mode field allows the user to select Not Qualified, Qualified, or
Directional
detection modes.
•
Not Qualified is the mode of operation where all of the sensors act
independently of each other and any single sensor can produce an alarm.