User's Manual

38 PB-007726 Rev - A
2005.07.04
4.5.5.5 Transmit voice
The Transmit voice field establishes the number of times a message will be
transmitted using the synthesized voice format. The count is selectable from
disable to 3 times. If the Voice Transmit Count is disabled, the PT-210M will not
transmit a voice message.
Note: If the Voice Transmit Count is other than disabled, and a Tamper detection
occurs, the Tamper event will be transmitted 3 times.
4.5.5.6 CTCSS Frequency
When voice transmissions are enabled, the PT-210M supports the addition of a
CTCSS (Continuous Tone Coded Squelch System) tone. To enable CTCSS,
select the desired tone frequency from the drop-down list control. To disable
CTCSS, select “None”.
4.5.5.7 Camera trigger pulse
Prior to transmitting a sensor event, the PT-210M can activate a camera trigger
output. The camera trigger output produces a momentary connection to ground,
often used to trigger an externally connected device (i.e. relay, still camera, or
video camera.) The camera trigger pulse width is adjustable from 0 to 1.5 seconds
in 50 millisecond increments.
Note: The camera trigger is NOT activated when transmitting a Status 1 or Status
2 event.
When finished, tap OK to return to the configuration screen. Tap Cancel to abort the
process.
Tapping the
Help
button initiates the Transmitter Section help system. From the menu
bar the operator also has access to the EIDS Help contents and to the TDS Recon help
contents. A Find feature allows the operator to search for a particular item.
Note: The menu bar selections at the bottom of the configuration screen are not available
in this operation.