User's Manual

6 PB-007726 Rev - A
2005.07.04
2.5.2 Secondary Source
An additional power source supplying +12 volts DC +/-12% may be connected externally
to the "AUX" connector. Connect pin "C" on the "AUX" connector to the + voltage and
pin "G" to ground.
3.0 PT-210 PC Configuration Software
3.1 Software Installation
1. Insert the EIDS Product Programming CD into the CD-ROM drive.
2. The CD should begin automatically, which will begin the setup/installation process. If
the CD does not begin automatically, select
START/RUN
and enter D:/setup (where D:
represents the drive letter assigned to the CD-ROM drive) and click OK.
3. Follow the instructions on the screen. Click Next to continue through the Setup process.
4. The PT-210 program may be launched upon completion of installation.