User's Manual

scientific literature. For example, over 120 scientists, engineers, and physicians from

universities, government health agencies, and industry reviewed the available body of

research to develop the ANSI Standard (C95.1). Nevertheless, we recommend that you use

a hands-free kit with your Smart Terminals (such as an earpiece or headset) to avoid

potential exposure to RF energy. The design of your Smart Terminals complies with the

FCC guidelines (and those standards).

Use only the supplied or an approved replacement antenna. Unauthorized antennas,

modifications, or attachments could damage the Smart Terminals and may violate FCC

regulations.

NORMAL POSITION:

Hold the Smart Terminals as you would any other Smart Terminals with the antenna

pointed up and over your shoulder.

RF Exposure Information:

This product is compliance to FCC RF Exposure requirements and refers to FCC website

https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC ID: 2AJ2B-

TPS980 to gain further information include SAR Values.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is