User's Manual

LTE Outdoor CPE12000 | User Manual 19

2. Connect the cable

• Remove the sealing cable gland plug from the gland nut.

• Open the sealing gland nut and remove it. Don not disassembles the gland base from

the bracket.

• Insert the cable into the sealing gland base and connect it to the RJ-45 connector at the

bottom of the CPE. Make sure the connector is completely inserted and tightened.

• Insert the rubber bushing on the cable into the gland base.

• Tighten the gland nut. Use the dedicated tool for fastening the sealing glands.

3. Seal the connector

• Attach the mastic tape (Scotchfil

Electrical Insulation Putty) and wrap it around the

connector butting up against the connector. Do not over stretch.

• Squeeze to tighten the mastic sealer. Make sure there are no air bubbles.

• Slide the cold shrink sleeve on top of the connector. Make sure that the sleeve covers

both cable connector and unit connector.

• Pull the cord slowly to shrink the sleeve.