System Manual

Page 30
When setting the CPE into the "L2 bridge" mode, verify that TSDF flow endpoint is configured
correctly – i.e. matching the BreezeWAY EPC virtual IP ("TSDF L2 end point IP Address"
value).
This should be configured in Network/ VPN tab. Verify that "GRE Destination IP address" is
matching the BreezeWAY EPC parameter "TSDF L2 end point IP Address" in Networking/
Virtual Network EPC menu.
 VPN Setting Under L2 Bridge Mode
Under the L2 Bridge connection mode, only L2 GRE can be configured as follows.
 L2 Service Under L2 Bridge Mode
Under the L2 Bridge connection mode, the user can use L2 Service configuration to manage
and tag 802.1p or DSCP for different VLAN packets.