System Manual

Figure [TBD]: Network/ Internet tab for Router/ NAT mode settings (modify screenshot IP Type to
IPv4)
3.8.1.2 L2 bridge mode
The following parameters should be configured (please, refer to the settings shown in the below
screenshot):
Connection Mode – defines the CPE networking mode. Should be set to "L2 Bridge"
MGMT and Data interface – not relevant for the L2 bridge mode. Leave default value "combined".
MTU – defines the Maximum Transmit Unit (maximum IP-level datagram size) before IP-layer
fragmentation. For L2 traffic, it should be changed to "Manual" with value "1600" (bytes). The actual
supported L2 datagram maximum packet size will be 1576 bytes.
IP Type – defines the IP stack of the CPE. The following values are available – IPv4, IPv6, IPv4v6 (dual
stack). Set to IPv4.