System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 100
Management > RM Settings (SNMP)
For SNMP, CPE serves as the server, users can use the tool such as MIB browser as the
client to connect to CPE and do remove control.
➢
SNMP Server: The type of the server. It includes SNMPv2c, SNMPv3.
➢
SNMP MIBS Version: 1.4.2
➢
SNMP Read-Only Community (SNMPv2 only): The “SNMP Community string” is like a
user id or password that allows access to a router's or other device's statistics. If the
community string is correct, the server responds with the requested information.
➢
SNMP Read-Write Community (SNMPv2 only): The “SNMP Community string” is like
a user id or password that allows access to a router's or other device's statistics. If the
community string is correct, the server responds with the requested information.
➢
SNMP Trap (SNMPv2 only): A way for an agent to send a asynchronous notification to
the trap server. The traps that an agent can generate are defined by the MIBs it
supports.
➢
SNMP Trap Community (SNMPv2 only): The “SNMP Community string” is like a user
id or password that allows access to a router's or other device's statistics. If the