System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 101
community string is correct, the server responds with the requested information.
➢
SNMP Trap Server IP Address: As titled.
➢
SNMP Trap Server Port: As titled.
➢
Contact: The name or organization responsible for the switch.
➢
System Name: The name that identifies the SNMP agent.
➢
Location: A location for the SNMP Agent.
➢
Latitude: A part of geo-location attributes.
➢
Longitude: A part of geo-location attributes.
➢
Height: A part of geo-location attributes.
➢
Reboot Requirement: A remainder to let users know that CPE needs to reboot to have
something taken effect.
➢
SNMP Access from LAN: Enable/Disable.
➢
SNMP Access Domain: Enable/Disable.
■ SNMP Access Domain IP Address: The IP address of the access domain.
■ SNMP Access Domain Netmask: The subnet mask for the access domain.
➢
SNMP Engine ID (SNMPv3 only): A unique identifier for the agent.
➢
SNMP Engine Boots (SNMPv3 only): A count of the number of times the SNMP engine
has re-booted/re-initialized since snmpEngineID was last configured.
➢
SNMP Engine Time (SNMPv3 only): The number of seconds since the
snmpEngineBoots counter was last incremented
➢
Trap Receiver Table (SNMPv3 only):
➢
Group Access Table (SNMPv3 only):