System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 104
Periodic Inform” is enabled.
➢ Connection Request UserName: When ACS connects to CPE, CPE also needs to
challenge ACS for authentication. ACS has to provide the username which matches
this field. (20 alphanumeric characters allowed)
➢ Connection Request Password: When ACS connects to CPE, CPE also needs to
challenge ACS for authentication. ACS has to send the password which matches this
field. (20 alphanumeric characters allowed)
If ACS does provisioning, there is no need for users to set connection request
username/password because ACS would send that to users.