System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 105
● RM Type-ODM-DM (Open Mobile Alliance Device Management) – NOT SUPPORTED
BY TELRAD
Management > RM Settings (OMA-DM)
Using OMA-DM (OMA – Device Management) the terminals can communicate with the
OMA DM Server and establish the configuration automatically. It’s the current standard
for activation of terminals in OMA (Open Mobile Alliance), it is designed for management
of small mobile devices such as mobile phones, PDAs and palm top computers.
➢ Global Settings
• Enable OMA Debug Message: Enable it, and then the debug message is printed
in the console.
• Provisioned: Configuration of the CPE, enabling and disabling features.
• Model ID Defined: Select “customize” or “read from system”.
• Model ID: As titled.
➢ Authorized Msg
• Server IP: The IP address or URL of DM Server for the CPE to connect to.