System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 106
• Server Port: Enter the port number of DM Server for the CPE to connect to.
• Server ID: The server ID for the CPE when connected to the DM Server.
• Server Password: The server password for the CPE when connected to the DM
Server.
• Server Nonce: Nonce is an arbitrary number used only once to sign a
cryptographic communication; the CPE and OMA-DM server use nonce to
authenticate each other if user selects MD5 as an authentication algorithm in
“Server Auth Type” field. (20 alphanumeric characters allowed)
• Server Authorized Type: Select the encryption algorithm from dropdown list
which used by DM Server to communicate with the client devices.
• Client ID: The ID of the CPE. It is used for DM server to connect to CPE.
• Client Password: The password of the CPE. It is used for DM server to connect
to CPE.
• Client Nonce: The CPE and OMA-DM server use nonce to authenticate each
other if user selects MD5 as an authentication algorithm in “Client Auth Type”
field. (20 alphanumeric characters allowed)
• Client Authorized Type: Select the encryption algorithm used by DM server to
communicate with the client devices.
➢ Bootstrap Settings
• Bootstrapped: To configure the CPE initially.
• Bootstrap Encrypted: To encrypt the bootstrap message.
• Bootstrap Method: To select bootstrap method.
• WIB Retry: The number of WIB retry.
• WIB Retry Interval: The interval of WIB retry.
➢ Polling Settings
• Enable Client Polling: The client can be able to do polling for tasks from server.
• Enable Server Polling: The server is able to dispatch works to the client directly
without queuing the tasks.