System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 17
● Mounting the ODU: Mount LTE Outdoor CPE on a 1”-4” pole using the supplied kit, or
the optional tilt accessory.
• Using the clamp
1.
Thread the M10*100mm bolt through a spring washer, flat washer and the bracket holes.
2.
With the connector facing downward, attaché LTE Outdoor CPE to a 1”-4” pole.
3.
Attach the bracket to the other side of the pole.
4.
Thread the M10*100mm bolts through both holes on either side, and tighten the nuts.
Connecting the Cables