System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 18
● Outdoor Connection: Connect a grounding cable between the Ground terminal of the
LTE outdoor CPE and a good ground connection.
●
Preparing and connecting the cable: Use only UTP-FTP 4x2x24AWG CAT. 5E outdoor
cable from an approved manufacturer. The cable provides pin-to-pin connection on
both ends.
1. Prepare the cable: Use a crimp too for RJ-45 connectors to prepare the wires. Insert
them into the appropriate pins and use the tool to crimp the connector. Make sure
to do the following:
• Remove as small a length as possible of the external jacket. Verify that the
external jacket is well inside the sealing cover when connected to the unit, to
ensure good sealing.
• Pull back the shield drain wire before inserting the cable into the RJ-45
connector, to ensure a good connection with the connector’s shield after
crimping.
The following figure shows the required wire pair connections. The color codes used