System Manual
Table Of Contents
- About this Guide
- Introduction
- Web Interface
- Reference Manual
- LTE
- Network
- Network | WAN Setting (Tunnel Mode – Layer 2 GRE Only)
- Network | WAN Setting (Bridge Mode) - NOT SUPPORTED BY TELRAD
- Network | WAN Setting (Router Mode)
- Network | LAN Setting
- Network | QoS (Available in NAT, Tunnel, Router Mode)
- Network | Routing (Available in Tunnel, Router Mode)
- Network | Port Management | Port Forwarding (Available in NAT, Tunnel Mode)
- Network | Port Management | Port Trigger (Available in NAT, Tunnel Mode)
- Network | DSCP
- Network | MGMT Service | Web Service
- Firewall
- Management
- Monitoring
- About
LTE Outdoor CPE | User Manual P. 25
device). At least one of these LEDs glowing continuously is an indication of successful
connection to the Base Station. Now you can start browsing the Internet.
Web Interface
Login to Web-GUI
Users’ devices are assumed in CPE LAN side. Please follow the steps below to configure your
device through the web interface:
Step1: Open the Web browser (Ex: Internet Explorer, Firefox or Chrome) and enter the
default IP address of CPE, which is : http://192.168.254.251
Web browser